null Skip to main content

MagSafe Phone Mount Install Guide - Ford Bronco

THANK YOU for purchasing the MagSafe Phone Mount for Ford Bronco from CravenSpeed. This product is made from the highest grade materials, and is guaranteed to be free from defects.

You can buy our CravenSpeed MagSafe Phone Mount for Ford Bronco here

Parts Included:

  • x1 CravenSpeed Phone Mount Bracket Assembly
  • x2 Bracket Spacers
  • x2 M6 Stainless Steel Cap Head Screws
  • x1 MagSafe Base
  • x1 Adhesive Ring

Tools Required:

  • T30 Torx Driver
  • 5mm Hex Driver

The installation time for this product is approximately 5-10 minutes.

If you have any questions/or concerns about this installation, feel free to send us an email at support@cravenspeed.com . We are always happy to help.

Installation Process

    The CravenSpeed MagSafe Phone Mount for Ford Bronco is a symmetrical design and may be installed onto either the left or right side of dashboard where the hand grips are affixed. Remove the upper two factory screws at the location of the hand grip with your T30 sized Torx driver. Store these screws in a safe place as we will not be reusing them for this install.

    Insert the spacers into the side of the phone mount assembly base and then pass the provided M6 cap heads screws thru from the opposite side.

    Set the bracket into place so that the spacers fit into the holes where the factory screws were and tighten the M6 cap head screws with your 5mm hex driver.

    With the bracket base now mounted securely, position the FlexArm into a convenient position for your chosen device. Your installation is complete!

!